ACID ETCH 45 is an aqueous blend of sulfuric acid, bifluoride, detergent, and inhibitors designed to rapidly clean and etch quarry tile, glass, porcelain, and rock hard surfaces in preparation for refinishing and top coating.

ACID ETCH 45 will effectively remove dirt, grime, and oil residue and etch the surface to allow for tight adherence of new finish coats or paint or glass. ACID ETCH 45 contains Sulfuric Acid and special care should be used in applying and rinsing.

Proper safely equipment

CRETE-SO-CLEAN is a specialized powdered detergent that has been specifically designed to remove dirt, oil, grease, lubricants, fuel, brake and transmission fluids from concrete and other hard surfaces. CRETE-SO-CLEAN is a non-caustic powder that is effective when spread over a water wet concrete surface, brushed and allowed to soak onto the surface for 15-30 minutes or longer depending on the soil. After soaking, flush the surface with high-pressure water. Hot water will enhance the

HYDRASPEC PG 40 is a water-soluble hydraulic fluid that is non-toxic, non-flammable, and biodegradable. This safety fluid contains a combination of anti-wear agents and rust inhibitors designed to make it suitable for use in a variety of hydraulic systems.

HYDRASPEC PG 40 is fire resistant by virtue of its water content (40%). Available in UN approved 5 gallon pails and 55 gallon drums.

SOAKTANK is a free flowing, non-volatile crystalline powder specially formulated to remove carbon, sludge, varnish and rust from ferrous metals in a soak tank. The product is non-fuming in dry or solution form.

SOAKTANK is effective at ambient temperatures and is even more effective when heated. Available in UN approved 50 pound pails and 450 pound drums.

SPEC LUBE 1510 is a concentrated, biodegradable, moderate pH water soluble rolling, drawing, cutting and cooling fluid that provides strong EP properties, rust protection and low surface tension to metal working fluids. SPEC LUBE 1510 provides excellent performance as an extreme pressure and lubricity additive, emulsifier, and rust inhibitor. SPEC LUBE 1510 is very effective when used as a replacement for oil based rolling lubricants, as an additive in for water based hydraulic fluids, and

SPECSOL 143 is a high flash, non-emulsifying solvent degreaser formulated to be used in parts washers to reduce the aromatic exposure to workers. It helps to provide a safer work environment while providing excellent cleaning capability on machined parts, tools carburetors, or any other equipment requiring hand cleaning. SPECSOL 143 will also help prevent rust and corrosion on newly cleaned parts by imparting a water displacing film onto metal surfaces. Available in UN approved 5 gallon, 6

SPEC SOL 63NC is a non-methylene chloride, non-butyl cellosolve, non-caustic soda blend of organic solvents that will penetrate, loosen and remove industrial paints, oil and grease and carbon deposits from ferrous and non-ferrous metal surfaces. When used as a paint clean-up solvent, it will effectively clean paint pots, lines, and guns without the danger associated with typical flammable paint thinners. SPECSOL 63NC is non-toxic and is considered biodegradable by EPA standards. SPEC SOL-63NC

SPEC STRIP 42C is a free flowing, non-volatile crystalline powder specially formulated with corrosion inhibiting properties to prevent metal attack when used in low to moderate cabinet pressure units. It will effectively remove grease, light carbon, loose paint and oily dirt from ferrous metal, aluminum, copper, brass and stainless steel without damaging the metal surface.

SPEC STRIP 42C does not contain caustic soda, and is non-fuming in dry or solution form. No corrosive gases form in

SPEC STRIP P is a free flowing, non-volatile crystalline powder specially formulated to remove carbon, sludge, varnish and rust from ferrous metals in a soak tank. This product is non-fuming in dry or solution form. It is effective at ambient temperatures and is even more effective when heated.

SPEC STRIP P is excellent for cleaning engine parts, for stripping paint from metal surfaces and for de-rusting ferrous metal. Available in UN approved 50 pound pails and 450 pound drums.

SPEC STRIP-42NC is a free-flowing, non-volatile crystalline powder specially formulated with corrosion inhibiting properties to prevent metal attack when used in low to moderate cabinet pressure units. SPEC STRIP-42NC will effectively remove grease, light carbon, loose paint and oily dirt from ferrous metal, aluminum, copper, brass and stainless steel without damaging the metal surface. SPEC STRIP-42NC is non-fuming in dry or solution form. No corrosive gases form in storage or during