General Description
LIQUID MOLY 210 offers excellent extreme-pressure lubrication in a non chlorinated system that air dries in as little as five minutes. LIQUID MOLY 210 provides superior extreme-pressure lubrication and requires little or no surface pretreatment. LIQUID MOLY 210 exhibits excellent adhesion for most substrates, especially metals. Ultra thin films vary from 0.2 to 0.5 mils and provide high lubricity and excellent release properties.Surface Preparation / Application / Curing
Substrates should be clean and dry. A solvent wipe or vapor degreasing and air dry is usually sufficient, however, sandblasting, phosphating or chemical etching will generally increase adhesion and wear properties. Stir product before application. LIQUID MOLY 210 can be applied by standard spray, brush, or dip methods, whichever is best for the job. Coatings air dry in 5 to 10 minutes and are then ready for use. When applied during periods of high humidity, the coating may become mottled in color. This does not effect performance.Physical Properties
| Color | Light to Dark Gray |
| Fluid Component | Anhydrous Isopropyl Alcohol |
| Density | 7.20 - 7.50 lbs./gal |
| Flash Point | 52º F |
| Lubricant | Molybdenum Disulfide |
| Coefficient of Friction | 0.23 (Static) |
| Service Temperature | 390º F |
| Intermittent Temperature | 660º F |
| Shelf Life | 12 months under original seal |